Race car build

This is our project build of a Porsche 928 race car , based on an early 1980 frame car with a  body kit. It will comprise components that are sourced from this model line , modernised with an Adaptronic e1280 body control module , that will control , engine management , rear trans-axle , with electronic diff control (stock components), along with experimental traction control , using the stock on-board speed sensors .

Dynotuning will design the logic too control all the features listed here , as the Adaptronic allows this access in its software design .

The photos attached will tell its story as it all unfolds , we started this process in June 2012 . We are hoping to have the car ready for testing, early in the race season of 2013

This is how the interior looked before everything was removed

Front view before dissassembly

Another view showing profile of the base car

G28/55 gearbox on workshop dolly prior to install

View from the side of the gearbox , note front oil pump lines for additional oiling

Note right side oil line entry , and front suxtion point

Drivers side view of engine and header assembly.

Side view of assembled engine showing custom passenger header exhaust.

Assembled engine from the front view showing the layout of the custom scavenge oil pump, alternator.

We have removed the mechanically assisted engine driven power unit and replaced with an electric unit .

custom 340 mm hats

custom 340 mm hats with future upgrades possible